I dont know if there is supposed to be water in the motorhead housing either. I am pretty sure if i silicone where the cord enters it will be okay. BUt is there supposed to be water in the housing?
XP3 Leak
So is start running my XP3 and it is running fine for a little bit and then it started to leak where the cord enters the housing. I looked in the troubleshooting which didnt really help. Should I silicone the o ring? Should i silicone from where it is leaking? What do I do? :-?
1 - 6 of 6 Posts
I think I am going to try and replace the o-rings on the quickdissconnect valve.
If you just bought it I would take it back, dont silicone anything just take it back.
it is used though. That link said to replace the quickdissconnect o=rings. And i checked the ones on the filter and they werent water tight thats for sure
1 - 6 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Cichlid Fish Forum
A forum community dedicated to Cichlid Fish owners and enthusiasts. Come join the discussion about breeding, health, behavior, housing, adopting, care, classifieds, and more!
Full Forum Listing
Recommended Communities
