Cichlid Fish Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2,596 Posts
Discussion Starter · #1 ·
I've been looking a good while for a used 100g. tank (60"X18"X18"). Finally found one for $50.00 but the add for it says..."The tank was drilled at the bottom but I have sealed it up and it holds water perfectly".

Do you think it will be ok? Are there any questions I should ask? 100g. is alot of water to clean up off the floor.
Thanks in advance for any advice.
 

·
Registered
Joined
·
2,596 Posts
Discussion Starter · #4 ·
You think it might have been drilled for a wet/dry filter? If so the hole would really be on the back of the tank and not the actual bottom, right?

I'll for sure check it out. I've been looking for this exact size for a good while. Some have come close in size but been deeper and being a shortie a don't want it so deep that I have to stand on something to get my hands down in the bottom of the tank. I hope it's still there to be had. Wish me luck lol.
 

·
Registered
Joined
·
2,596 Posts
Discussion Starter · #5 ·
Oh I forgot to mention that the tank is acrylic. Wouldn't that be easier to seal than glass if it's not ok to use a wet/dry with it.
 
1 - 3 of 3 Posts
Top