Cichlid Fish Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
45 Posts
Discussion Starter · #1 ·
Good morning,

I have an aqueon 40g breeder as a sump and I'm utilizing acrylic for over the edge equipment holders (heaters, a float switch & in line for the ATO). I forgot the measure the width of the top trim on the tank before I left this house this morning and wanted to ask the community if someone could measure theirs for me.

I'd thought about cutting the needed dimensions but have access to a quality heat gun at work and decided I'd rather mold it for a cleaner look.

Thank you!

Evan
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top