Cichlid Fish Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
Hey, I have a 2 Penguin 200s running in my 55 Gal tank. One is older and the other is new. My older one's biowheel stopped turning. It doesn't look like water flow is terribly slow (although it is less than the new one). Does anyone have any answers to what's happening? Is this bad thing, or can I leave it be?

thanks
 

·
Registered
Joined
·
127 Posts
I have the same filter and had the same problem. Like the above post says, you have to take it apart and clean it. concentrate on the intake tube and impeller. I just used a paper towel and wiped all of the sludge off, an old toothbrush(thoroughly rinsed off) to clean inside of the intake tube, put it back together and good as new. :thumb:
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top