[MightyWarMonger]

I got my LED for my moon light but I'm not sure exactly how to wire it. I was thinking if getting an extention core and cutting of the end and attaching it that way but I wanted to see if any one had any other ideas. I've attached some pictures so you can see what I got. there are two leads on the end so I can chain multiple lights together. I have two but was going to start with one to see how bright it was before I add the second one. so any thoughts?

 

[under_control]

Um... you can't just hook it into an outlet. You need to know what voltage it runs at. It will need a power supply. Not 120v, I can promise you that. You'll blow those lights pretty much immediately.

 

[MightyWarMonger]

Here is what I found on them from the place I bought them looks like 12v, So do I get some kind of volage regulater or what?

12 Volt Stainless Steel Led Accent Lights

All Stainless Steel Housing For Thru Hole Mounting in a 16mm diameter (5/8" diameter hole).
Fully Waterproof
4" dual wire leads allow lights to be easily strung together
4" Dual Leads can be Lengthened as needed using the bullet style connectors (sold below)
Draws only 20 milliamps of power
Great for underbody and indoor - outdoor use

Would this work for converting them? it says
72mm x 55mm x 48mm Deep

2-7/8" x 2-1/8" x1-7/8" Deep

120 Volt AC input.

12 volt DC output..

Standard 2 prong wall plug

6' cord for 12 VDC Output

http://superlumination.com/images/auto_ ... er_18w.jpg

 

[under_control]

where did you but them from? I bet they have the power supply you need.

 

[MightyWarMonger]

Ok thanks I think I will be getting the one listed above (I edited my post)I belive these are DC power anyway and this will convert AC to DC and 120v down to 12v so we shall see thanks.