Air Pump & PVC loop for fishroom. please advise
2
hi,
I purchased an airpump for my fishroom
![]()
Hi Blow 80 Pond Air Pump Ref: HP80
Exhaust Air Flow Rate: 80 Lt/min
Voltage: AC100/120/220~240
Power consumption - 71w
Frequency - 50/60 Hz
I am planning to build a loop from pvc pipe around the ceiling of the fishroom
and then connect the airline for up to 30 tanks to the loop using these manifolds
![]()
However, from reading around
http://www.tedsfishroom.com/wp/fishroom/air-system
"...When installing the air plumbing, think about loops. Air pressure is maintained evenly in a system that does not have any dead ends. My room has a large bisected loop. The loop goes completely around the room and a pipe runs across the center of the room connecting opposite sides of the loop. I used 3/4″ pvc for the plumbing. This is another area of savings over a regenerative blower, which uses 2.5″ pvc adn fittings. The cost difference between plumbing the air with 3/4″ vs/ 2.5″ PVC is significant."
So does this mean that with my pump i will have to use 2.5 inch PVC, or can i build a loop out of 3/4" with my pump, which isnt a linear piston pump, but instead a linear diaphram pump.
Has anyone any experience with this.. i'd love to use a loop of smaller diameter, but i have the pump already so i will work around this..
Hope you can help
I purchased an airpump for my fishroom
Hi Blow 80 Pond Air Pump Ref: HP80
Exhaust Air Flow Rate: 80 Lt/min
Voltage: AC100/120/220~240
Power consumption - 71w
Frequency - 50/60 Hz
I am planning to build a loop from pvc pipe around the ceiling of the fishroom
and then connect the airline for up to 30 tanks to the loop using these manifolds
However, from reading around
http://www.tedsfishroom.com/wp/fishroom/air-system
"...When installing the air plumbing, think about loops. Air pressure is maintained evenly in a system that does not have any dead ends. My room has a large bisected loop. The loop goes completely around the room and a pipe runs across the center of the room connecting opposite sides of the loop. I used 3/4″ pvc for the plumbing. This is another area of savings over a regenerative blower, which uses 2.5″ pvc adn fittings. The cost difference between plumbing the air with 3/4″ vs/ 2.5″ PVC is significant."
So does this mean that with my pump i will have to use 2.5 inch PVC, or can i build a loop out of 3/4" with my pump, which isnt a linear piston pump, but instead a linear diaphram pump.
Has anyone any experience with this.. i'd love to use a loop of smaller diameter, but i have the pump already so i will work around this..
Hope you can help
