Haplochromis sp. ''Dayglow'' Cichlid-Forum  
  Home  |  Library  |  Forum  |  Species Profiles  |  Aquarium Gallery  |  Product Reviews  |  Retailer Reviews  |  Classifieds  |  Sponsors  |  Clubs Chat empty  
Product Reviews
5492 reviews on 1118 products!

ProductsMiscellaneousBreeding/Isolation Units
Aquarium Products Self Cleaning Breeding Unit
Login to Review »
Product Description:
Aquarium Products Self Cleaning Breeding UnitThis revolutionary breeding unit actually circulates aquarium water through the breeding unit. Unique fresh flow system can be used as either a breeder or isolation unit. The built-in air diffuser continuously re-circulates oxygenated aquarium water through an adjustable spray bar. Excellent for use with pregnant females, livebearer fry, injured, or bullies/bullied fish. Two suction cups are provided to attach the unit to the inside aquarium glass. Breeding unit is divided into two upper and lower sections. Can also be used as a standard breeding trap if the water circulation system is turned off. Requires the use of a small air pump and airline tubing.
Product Specifications:
Measures
approximately 7-1/2" x 3-1/2" x 4-1/2" tall.
User Ratings: (1 reviews)
Overall: 6.50
Value/Cost: 5.00
Effectiveness: 7.00
Quality: 7.00
Ease of use: 7.00
  Login to Review » User Reviews    
Found: 1 reviews Page  
JJSJR has used this product for 3-12 Months.
Overall Rating: 6.5/10 July 27, 2003
"Ahhh, OK I guess"
I can NOT recommend this product. I found it was made out of VERY thin plastic "typical of the current economy" and 2 of the three on the shelf were cracked. The lid is difficult to remove while in the aquarium. I took out all of the useless inserts and used it to house fry still with slight egg sacks. Personnally I found using a MUCH thicker acrylic Aqua Culture Dual Betta Kit was a whole lot better. I simply drilled 5 columns of 13 holes on each of the narrow sides 1/4 inch apart at 3/32 dia. and four holes on one wide side 3/8 thick with a spade bit after a 3/32 pre-drill for some hanger suction cups from Wal-mart and it works great. I also side cut a 1/4 inch hole in the lid for an air stone. All for less than 7 bucks.
  Login to Review » Page      
             
Ratings are submitted by Cichlid-Forum users based upon their own subjective views and do not necessarily reflect the opinions of Cichlid-Forum.com. CF disclaims any responsibility for the accuracy of information contained in reviews submitted by users, or for any damage or liability arising from the content of any review appearing on Cichlid-Forum.com. All product information on this site, including descriptions and specifications, is based soley on information made available by manufacturers. CF disclaims any responsibility for this information or the products listed. Product information may be inaccurate and is subject to change without notice. You should confirm all information before relying on it by contacting either the manufacturer or vendor with any questions about the products or the information presented.






Copyright © 2019 Cichlid-Forum.com. All Rights Reserved.
F.A.Q.
 
Login to access your personal folder.

0 User(s) in Chat
91328 Members
862901 Posts
664 Classifieds