Equipment & Supplies • Sulfur reactor not working

For discussion regarding filters, lights, heaters, pumps, etc.

Moderators: Deeda, Kanorin

Sulfur reactor not working

Postby Chas2001 » Wed Apr 29, 2020 9:02 pm

I'm looking for a suggestion to get my first sulfur reactor working. It's installed on a 350L (about 92 gallons) freshwater tank (containing a heavy population of Malawi cichlids). My nitrate levels are high. I'm doing 75% water changes per week. The reactor is a cylinder 8cm (about 3 inches) in diameter that contains 1 litre (about .26 US gallons) of Deltec sulphur beads in the lower chamber and the same amount of coral rubble in the upper section. I started off with a drip rate of one drop per second, with no change in nitrate in the first couple of weeks. Then I adjusted it to one drop in two seconds, then continued to one drop in 10 seconds. It's been operating for about nine weeks and there is no change in the effluent nitrate level compared with the main tank water. There has been no smell of sulfur. Suggestions would be very much appreciated. Thanks.

Chas 2001, Australia
Chas2001
 
Joined: Fri Jun 08, 2018 3:50 am
Location: Brisbane

Share On:

Share on Facebook Facebook Share on Twitter Twitter

Return to Equipment & Supplies

Who is online

Users browsing this forum: No registered users and 15 guests