Equipment & Supplies • Leaking Eheim 2028

For discussion regarding filters, lights, heaters, pumps, etc.

Moderators: Deeda, Kanorin

Leaking Eheim 2028

Postby Dennis » Tue Jun 12, 2012 5:00 pm

I purchased a used Eheim 2028 on Ebay a few months ago. It was fine for a few wks., but now leaks in the power head area. I have another 2028 that I bought new 5or 6 yrs. ago. On the new one I just got, I replaced the sealing gasket as I have had to do with the other one on occasion. It turns out after further inspection and leakage that it seems to be leaking inside the power head. Does anybody have any ideas where to look before I shell out some big bucks for a new powerhead, if I can find one? :(
Dennis
 
Joined: Sun Feb 09, 2003 3:34 pm
Location: Florida

Share On:

Share on Facebook Facebook Share on Twitter Twitter

Re: Leaking Eheim 2028

Postby 748johnd » Tue Jun 12, 2012 7:56 pm

The leak is probably coming from the priming plunger. There is an O-ring that can be replaced or lubricated, but it is tricky to get the plunger assembly out.
Check out these sites. http://www.njac.net/articles/eheim_oring.htm and http://www.atomicrice.com
Hope this helps.
User avatar
748johnd
 
Joined: Sat Jun 30, 2007 10:02 am
Location: Rochester, NY

Re: Leaking Eheim 2028

Postby Deeda » Tue Jun 12, 2012 9:40 pm

Perfect advice from the above poster. I have used the article and the seller to get my 2028 back in working order. As far as I am aware, the posted link is the only available location to purchase the primer pump o-ring.
Deeda
Moderator
 
Joined: Sun Jan 09, 2005 6:49 pm
Location: Medina, Ohio, USA

Re: Leaking Eheim 2028

Postby Dennis » Wed Jun 13, 2012 4:59 pm

Thank you for the replies and the websites. Will definitely give them a look. Thanks again. I wish Eheim would just do away with that priming mechanism. I never use it.
Dennis
 
Joined: Sun Feb 09, 2003 3:34 pm
Location: Florida

Re: Leaking Eheim 2028

Postby Jmanolinsky » Thu Jun 14, 2012 11:47 am

My 2026 was leaking in the primer pump area. I followed directions I found here, disassembled and cleaned, applied vaseline to the o-ring and reassembled. This worked for me.
Jmanolinsky
 
Joined: Fri Jun 04, 2010 9:25 am
Location: Knoxville, TN


Return to Equipment & Supplies

Who is online

Users browsing this forum: No registered users and 4 guests